 KaStang
Costs and Schedule of Work:  |
| Date |
Work |
Approximate
Cost |
| 20-MAY-2002 |
Original Purchase of Vehicle |
$6000 |
| 03-JUNE-2002 |
Replace Radio Antanae |
$16 |
| |
Installed Pertronix Electronic Ignition,
Flamethrower coil, Bosch 7mm Wires |
$110 |
| 20-JUNE-2002 |
Finally tuned the engine. Found that initial timing was around
30 degrees advanced when it should only have been 6 degrees BTDC |
$150 for tuning tools |
| 06-JULY-2002 |
Installed Edelbrook IAS Shocks (front
only) |
$120 |
| 12-AUG-2002 |
Installed new radio in glove compartment |
$150 for radio
$50 for 2 new speakers
$100 for Install |
| 16-AUG-2002 |
Drained and flushed Radiator and Cooling system, Replaced
Thermostat with 180 degree thermostat. |
$6 Thermostat
$1 Gasket
$10 Coolant |
| 17-AUG-2002 |
Replaced Tires with Goodyear Regatta 2 205/70 R14 |
$387 |
| 22-AUG-2002 |
Flushed Radiator, Installed New 6 bladed Flex Fan |
$80 |
| 29-AUG-2002 |
Replaced Water pump |
$40 |
| 02-SEP-2002 |
Replaced Radiator |
$169 |
| |
Replaced Carter RBS Carb with Rebuilt Autolite 1100 |
$101 |
| 01-OCT-2002 |
Repair to Unibody rust |
$5000 |
| 01-NOV-2002 |
Rust Repaired by
Mid County Mustang, Upper Uwchlan PA |
|
| 16-NOV-2002 |
Purchased Cobra Air Intake |
$60 |
| 20-NOV-2002 |
Purchased Double Roller Timing
Set |
$90 |
| 29-NOV-2002 |
Completed Engine Tear Down |
|
| 10-DEC-2002 |
CC'ed Combustion Chamber, Removed
Valves |
|
| 22-DEC-2002 |
Removed Engine |
$200 Engine Hoist
$50 Load Leveler
$20 For dinner for my friend |
| 24-DEC-2002 |
Port and Polish Exhaust Ports |
$30 for Bits/Dust Mask |
| 06-JAN-2003 |
Completed Offenhause Intake
Modifications |
$30 for Drill Bits/ Dust Masks |
| 10-JAN-2003 |
Clifford 6-2 Dual Exhaust Headers |
$120 |
| Between 18-JAN and 08-JUN-2003 |
T-5 installation |
$250 for T5
$200 for Adaptor Plate
$150 for T.O. Bearing, Pressure Plate, Clutch Disc
$150 for T-5 Shifter
$80 for T-5 Slip Yoke
$150 for Drive Shaft Modifications
|
| Engine Installation |
$200 for Misc. gaskets. |
| Engine Compartment Re-Wiring |
$120 for Headlight Harness
$50 for Alternator Harness
$50 for Gauge Feed Harness |
| 14-AUG-2003 |
New Carpet, Insulation, Sill Plates, Interior Paint |
$200 |
| MSD Digital 6 Plus Ignition |
$280 |
| Duraspark 2 Distributor, cap, coil and 8mm
wires |
$110 |
| 10-NOV-2003 |
Aussie 250/2V head/intake |
$600 |
| Ford Six Parts Dual Out, Ceramic Coated headers |
$380 |
Aussie 250/2V head rebuild
- Enlarged Valves
- Hardened Valve Seats
|
$500 |
| 15-DEC-2003 |
ARP Head bolts |
$50 |
| ARP Header Studs |
$40 |
| Thin .027" Head Gasket (to restore CR) |
$40 |
| Mr. Gasket 2-4V carb adaptor (MRG-1933) |
$40 |
| Tower Brace Kit (Custom Made) |
$225 |
| 24-JAN-2004 |
Grab-a-trak Rear leaf Springs |
$260 |
| Edelbrock Performer IAS (4 new) |
$240 |
| NPD 480#, 1" lowering springs |
$80 |
| Dual MC swap |
$90 |
| |
|
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
| TOTAL COST TO DATE: |
$16550 |